95 pure zirconia microspheres are used as the key raw material for zirconia ceramics, and its application has also expanded with the continuous development of the application scope. Moreover, in the current porcelain sales market, the slow prevalence and application of porcelain parts have also promoted the development trend of the zirconia microbead manufacturing industry. With the application of new technology and application of new technologies, it has fully mobilized its heat resistance, corrosion resistance, wear resistance and distinctive mechanical strength. All countries have paid attention to it in various industries such as function and structure. , All emphasizing special effects. It is used in industries such as industry, machinery automation, communications, electronic devices, trolleys, metallurgical industry, electric energy, and microbes.
Chemicals such as zirconia first appeared in a foreigner who was extracted from spar, and then used on natural gas lamp covers. Since then, these materials have been used in fire-resistant insulation materials, coloring and wear-resistant materials. Expanding the main uses of zirconia to construct raw materials and functional materials is one of the new performance materials that encourage the development trend of the industrial policy. 95 pure zirconia microbeads are made of millimeter-scale silica zirconia and yttrium oxide as raw materials. They are used to finely mill and disperse the raw materials with "zero environmental pollution" and high viscosity and high toughness. Mill beads.
The matters needing attention of 95 pure zirconia beads are:
1. According to the volume of the sand mill, the viscosity of the slurry and the outlet gap, select the appropriate zirconia beads. When using it, you must first clean the inside of the sand mill, and determine whether the viscosity of the slurry meets the requirements, and check whether the outlet gap and speed of the sand mill are appropriate.
2. When using for the first time, it is recommended to pre-mill for 30 minutes in a certain viscosity resin and solvent slurry. If low-concentration slurry pre-grinding is used, the speed must be reduced and the operating time should be controlled within 15 minutes.
3. Due to long-term grinding, a small amount of micro-beads will break under high-speed impact. Therefore, after a period of time, a part needs to be added. When replenishing, first use a sieve to sieve out the broken, and then add new beads with the same weight as the broken beads.
4. When using its abrasive paint, it is recommended to use resin to clean it. If you need to use a solvent, you need to reduce the speed; the operating time is controlled within 10 minutes. It is recommended to use "start-stop" intermittent cleaning.
5. If the fineness requirements of the product remain unchanged, if the grinding time needs to be extended, or if the fineness cannot be achieved within the specified time, 95 pure zirconia microbeads need to be supplemented with an appropriate amount.
